Yellow Snow Synthetic Urine

Instructions in package:

1. Shake bottle well before and after heating.

2. Heat Yellow Snow in microwave for up to 10 seconds. Be sure to pop up the top before heating to release pressure.

3. If the temperature is not 94 degrees on the thermometer, put back in microwave for an additional 5 seconds. If you do not see any reading on the thermometer, it is not broken: the sample is either too hot or too cold. Let Yellow Snow cool down and reheat again.

4. After heating, close cap and shake the bottle well to make sure there is no settling on the bottom. Then activate the enclosed heating pad by removing from foil pouch and shaking well. next, attach heating pad with the enclosed rubber band, to the side of the bottle opposite of the temperature strip. Do not remove heating pad (heating pad will last up to 6 hours). If you do not use that day, you can re-heat on another day.

5. If you are not using a microwave to heat the Yellow Snow sample, and are using the heating pad, you must activate the pad by shaking well to mix contents. Attach heating pad with the enclosed rubber band to the bottle opposite of the temperature strip. It will take 1 hour to heat the sample to 90F - 100F with the heating pad. Do not removed the heating pad. Heating pad will last up to 6 hours. Just before use, verify temperature is between 90F - 100F.

6. Shake bottle well just before using Yellow Snow. Then simply flip up spout on cap and squeeze. Yellow Snow will flow and look like real urine.